Module Controllers
Concurrent Tecnologies PP410/032-12

Transition Board Setup
	The switches SW1,SW2,SW3 and SW4 should all be set to on to enable
	the back panel Ethernet ports.

BIOS setup from factory defaults:
	1. Enable the "PXE Boot Firmware" to use the Front Panel Ethernet
		port for boot in the "Advanced/PCI Configuration" screen.
	2. Disable the "Front Eth" and "Rear Eth B" Ethernet ports. Note
		that due to a BIOS error the "Front Eth" setting actualy
		applies to the "Rear Eth A" Ethernet port.
	3. Setup BIOS to retry boot indefinitely. This is done using the
		"Auto-retry On Boot Fail" option in the "Boot Features" menu.
	4. Saved BIOS settings as user defaults.